Epothane is a seamless, high-strength industrial floor coating system based on epoxy resin. Depending on the thickness and surface type selected, it carries loads ranging from light to very heavy traffic. With its chemical resistance and easy-to-clean surface it is used in production and storage areas.
-
1
Astar
Required
Main Product FOX EPOTHANE PRIMER HB~0.3 kg/m²Damp surfaces
Alternative FOX EPOTHANE PRIMER~0.8 kg/m²Dry surfaces
-
2
Waterproofing
Required
Main Product FOX PURMAX ULTRA~1.2 kg/m² -
3
Wear Layer
Required
Main Product FOX PURMAX EP 2K~1.8 kg/m² -
4
Son Kat Kaplama
Required
Main Product FOX PURATHANE TOPCOAT~0.6 kg/m²Alternative FOX PURATHANE TOPCOAT UV~0.6 kg/m²UV resistant
Product Description
Epothane is a family in which the floor load and the chemical exposure determine the system choice. Antistatic, decorative or self-levelling finishes allow different performance classes to be built on the same base; as the layer thickness increases, abrasion and impact resistance rise.
Anahtar Faydalar
- High mechanical and chemical resistance
- Easy-to-clean, dust-free surface
- Long-lasting and easy to maintain
- Available in a range of colour options
Avantajlar
- Dissipates static electricity from the floor.
- High mechanical strength.
- Parlak son kat kaplama elde edilir.
Technical Specifications
System Detail
Areas of Use
- Indoors,
- On industrial floors with increased protection requirements against electrostatic discharge,
- In areas containing sensitive electronic equipment,
- Used in areas with a high risk of explosion.
Application Steps
- 1
Surface Preparation
The floor is opened by milling or shot blasting; dust, oil and loose particles are removed completely.
- 2
Astar
A primer suited to the surface moisture is selected; quartz sand is broadcast onto the fresh primer.
- 3
Ara Katmanlar
Depending on the system type, a waterproofing and/or wear layer is applied.
- 4
Son Kat
The top coat is applied in the selected colour and left to cure in a dust-free environment.
Which surfaces can the system be applied to?
Applied to sound, load-bearing floors with sufficient tensile strength. Surface moisture must not exceed 4%.
When can it be put into service after application?
Light use is possible 24 hours after the top coat, and full load after 7 days.
Can it be applied over an existing coating?
If the adhesion and strength of the existing coating are sufficient, it can be applied after surface preparation.
Surface moisture must not exceed 4%. At high moisture the primer adhesion drops and blistering occurs.
Application must not proceed without observing the waiting times between coats.
Slight shade differences may occur between production batches; using a single batch in the same area is recommended.
Products used in the system
Fox Bau products used in the layers of this system.








